![]() Wheelbase, front track, rear track American Motors Find brake drum width, multiply X two and add that figure to the plate to plate dimension to get flange to flange. This information will require knowing the width of the brake drum to determine flange to flange dimensions. The third section will list backing plate to backing plate on the rear differential. The only difference between the two would be the thickness of the material of the two drums or brake rotors/discs at the studs. Drum to drum would be close enough to the same if that's all the information you have to post. The second section will be listed as axle flange to axle flange where the wheel bolts on. There are also "Inner track" and "Outer track" dimensions, measured from the center lines of the inner tires and the outer tires of the dual wheel axle. On vehicles with dual wheels, that measurement is commonly taken from halfway between the centers of each tire on both right and left sides. Track is the dimension from the centerline of the tire tread on one tire to the centerline of the tire tread on the opposite tire on the same end of the vehicle. Note that the measurement could also be described as being between the center points of the circles described by the front and rear wheels on the same side of the vehicle. Most often, wheelbase is the dimension from the center point at the end of the front axle or spindle to the center point of the end of the rear axle. If the wheelbase were known, but the front and rear track were unknown, it would be listed as 86.0, NA, NA - 1952 Morris Minor. For instance, if the wheelbase of the Morris were unknown, it would be listed as NA, 50.6, 50.3 - 1952 Morris Minor. If one or more of the dimensions are unknown, NA should be inserted in that space. Dimensions will be listed left to right as wb/ft/rt followed by the year, make and model of the vehicle. The first section will list wheelbase, front track and rear track of vehicles in inches, so that those interested in frame swaps or clip swaps can find the correct donor vehicle. This article will be divided into at least three sections Introduction All measurements are in inches unless otherwise noted. 6.2 These measurements are from brake drum to brake drum (WMS-WMS):.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |